'12-'17 Kia Rio/Hyundai Accent axle back exhaust.

This is a custom made muffler set-up for a Isuzu Rodeo or Honda Passport using a Magnaflow Off-Road Pro muffler. Magnaflow does not make a bolt-on muffler for Isuzu or Honda. The front pipe has been cut off on yours for some reason. The rear mount pin has been welded onto the muffler instead of on the rear pipe where it would normally be on a stock muffler probably because of a difference in length. The URL's show a couple of direct replacement mufflers and pipes sold by Mac Auto Parts. The mounts on those are shown in the original factory positions. The front mounting on yours has been made to fit the original Izusu exhaust hanger but uses welded-on pins instead of a bolt-on bracket on the rear. This would fit the 2.2L and 3.2L vehicles with the correct pipe on the front.

References:

https://www.ebay.com/itm/Honda-98-02-Passport-Isuzu-98-04-Rodeo-3-2L-Muffler-...

https://www.ebay.com/itm/2001-2003-Rodeo-Sport-2-2L-Muffler-Tail-Pipe-Exhaust...

https://www.carid.com/1998-isuzu-rodeo-exhaust-parts/bosal-rubber-mounting-95...

Reason:
Hi, thank you for the opinion, I looked little further into this, and looks like this muffler is part of the Magnaflow Off Road Pro Series and the cut of tip is a Turndown Tip, but I am still having trouble locating the fitment,

Those are some fat@ss exhaust hangers, so that leaves out Honda. This looks like it should go on the rear of the vehicle on the driver side. Rear hanger weld penetration isn't very good, welder was probably afraid of poking a hole through the stainless steel. I've see this hanger configuration before, but gosh dangit I never paid attention to what car I'm under!

References:

http://ffauploads.com/muffins.jpg

Reason:
good answer, but need little more

'12-'17 Kia Rio/Hyundai Accent axle back exhaust.

References:

https://kdmtuners.com/product/evilla-motorsports-kia-riohyundai-accent-axle-b...