An expert got paid $6.00 to identify this. Become an expert today.
This is half of a pipe or round tube bending die set, most likely patterned to fit a JD Squared model 3 bender, or similar. It is the lower receiver block, which holds the material steady and feeds it into the round die. This is an older one-piece example. Newer sets include a three-piece die, with the two curved 'cups' bolted perpendicular to a flat plate.
Bounty: $6.00
Posted By: HelpIdentify
I'd Like to Know:
I would like to know what this is exactly, what it does, what it's used for, what it goes to and who manufactures it. Thanks.
Item History: N/A
Size: It is approximately 5-1/2" in overall length, 4" wide, 1-1/2" thick.
Markings: 'Top 1x4 240'.
Opinions
1)
This is half of a pipe or round tube bending die set, most likely patterned to fit a JD Squared model 3 bender, or similar. It is the lower receiver block, which holds the material steady and feeds it into the round die. This is an older one-piece example. Newer sets include a three-piece die, with the two curved 'cups' bolted perpendicular to a flat plate.
References:
By: colindoyle Submitted on: 04/12/2016 at 02:00PM
Accepted